Air Circulation; Installing The Projector Properly - Eiki LC-XN200 Owner's Manual

Safety Instruction

Air circulation

Vents in the cabinet are provided for ventilation.
To ensure reliable operation of the product and
to protect it from overheating, these openings
must not be blocked or covered.
Caution
Hot air is exhausted from the exhaust vent.
When using or installing the projector, the
following precautions should be taken.
- Do not put any flammable objects or spray
can near the projector. Hot air is exhausted
from the air vents.
- Keep the exhaust vent at least 1 meter away
from any objects.
- Do not touch a peripheral part of the exhaust
vent, especially screws and metallic part. This
area will become hot while the projector is
being used.
- Do not put anything on the projector. Objects
put on the cabinet will not only get damaged
but also may cause fire hazard by heat.
Cooling fans are provided to cool down the
projector.
The fan's running speed is changed according
to the temperature inside the projector.
Air Intake Vent
Exhaust Vent
6
Air Intake Vent

Installing the projector properly

Be sure to use the projector properly in the
specified position. Improper positioning may
reduce the lamp lifetime, and even cause
grave accidents or a fire hazard. The projector
can project images upwards, downwards or
slantwise in the direction vertical to a horizontal
surface. When slantwise installing the projector
downwards, make sure its bottom upturned.
√ Note: To turn over an image, please set the
function of Ceiling On.
Notes on Projector Positioning During
installation, avoid the project positioning
manners as described below.
Do not roll the projector over 10
10
degrees from side to side.
10
Do not put the projector on either
side to project an image.
Caution in ceiling installation the projector
- Only qualified personal is authorized for ceiling
installation.
- We are not responsible for the hurt and
damage caused by ceiling bracket that
purchased from unauthorized dealer even in
warranty period.
- Remove the ceiling bracket immediately while
not use.
- While installing, torque screwdriver is suggested,
don't use electric or impact-type screwdriver.