Pole Mounted Installations - Extreme Networks Altitude 4760 Series Installation Manual

Altitude 4760 Series Access Point Hardware Mounting and Installation
The following ancillary hardware to attach the extension arm to the mounting hardware kit
sections is included in the extension arm kit.
Description
1/2 inch hex head nut
1/2 inch x 3/4 inch hex head bolt

Pole Mounted Installations

The mounting hardware kit and extension arm can be used in various combinations to
properly install the Altitude 4760 Series Access Point on a pole. For poles of up to 3 inches
in diameter, attach the pole mount section of the mounting hardware kit at the desired
position on the pole using band clamps up to 3/4 inch width, or a 1/2 inch U-bolt and nuts.
For poles greater than 3 inches in diameter, attach the pole mount bracket section using
band clamps.
CAUTION
Always mount the Altitude 4760 Series Access Point with the black gore vent facing down.
NOTE
The U-bolt and band clamps are not included in the mounting bracket kit.
NOTE
Use of the extension arm is recommended for installations on poles greater than 3 inches in
diameter.
Altitude™ 4760 Series Access Point Installation Guide
Quantity
2
2
29