Altitude 4760 Series Access Point Ports and Connections
Altitude 4760 Series Access Point Grounding Screw
The grounding screw is located to the right of the GE1/POE port and above the GND
symbol.
WARNING!
The grounding cable for an Altitude 4760 Series Access Point must be at a minimum a #10
gauge wire cross section.
The grounding cable can be attached to the unit using one of three recommended methods.
Using an 8mm socket and driver:
Loosen the grounding screw and insert the grounding cable into the hole below it.
●
Tighten the grounding screw to 30 inch pounds (lbf-in).
Loosen the grounding screw and wind the grounding cable around the screw. Tighten
●
the grounding screw to 30 inch pounds (lbf-in).
Attach a ring lug to the grounding cable and remove the grounding screw to attach the
●
ring lug to the Access Point. Secure it to the unit by reinserting the grounding screw.
Tighten the grounding screw to 30 inch pounds (lbf-in).
Altitude™ 4760 Series Access Point Installation Guide
21