Extreme Networks Altitude 4760 Series Installation Manual page 36

Altitude 4760 Series Access Point Hardware Mounting and Installation
6 To adjust the position of the Access Point, rotate the Access Point bracket section (plus or
minus 15 degrees) and tilt the angle adapter bracket section (up to 45 degrees).
7 Tighten all hex flange screws to 60 inch pounds (lbf-in).
To use only the extension arm:
1 Using four #10/32 lag bolts, attach the extension arm at the desired mounting location.
2 Using a torque wrench, or a ratchet and a 10mm socket, or an adjustable wrench, attach
the mounting extension arm to the Access Point with four M6 hex flange screws. Tighten
the hex flange screws to 60 inch pounds (lbf-in).
To use the extension arm with the mounting hardware kit:
1 With the open slot connections facing down, attach the angle adjust bracket section at
the desired mounting location using four #10/32 lag bolts.
2 Complete the steps for assembling and positioning the angle adapter and Access Point
mounting bracket sections outlined above.
3 With the Access Point positioned so that the gore vent is facing down, attach the
extension arm to the Access Point bracket section of the assembled mounting bracket
already in position using four M6 hex flange screws. Tighten the hex flange screws to 60
inch pounds (lbf-in).
Altitude™ 4760 Series Access Point Installation Guide
36