Install The Access Point On A Pole - Extreme Networks ExtremeMobility AP460i Installation Manual

3 Align the large holes and assemble both the stiffener plates inside the AP attach assembly plate.
Figure 9: VMM access point attach assembly plate stiffener #1 and stiffener #2
4 Attach four M4 or M6 screws to stiffener plate #2 and align the AP's threaded holes to the AP attach
assembly plate.
The screw head goes inside the small bracket with the bent sides.
Note
The bracket comes with four M4 screws.
5 Tighten the screws to 10 in-lbs.
6 Align the AP attach assembly plate to the vehicle attach assembly plate and tighten using four
thumbscrews.
Note
The access point will not be centered and some of the attachment holes in the access
point attach assembly plate will be visible.

Install the Access Point on a Pole

You can install the access point on a pole using the following mounting brackets:
•
KT-147407-02 bracket parts
•
KT-147407-02 pole part
ExtremeMobility AP460i/e Outdoor Access Points
Install the Access Point
20