Pole Mounted Installations - Extreme Networks AP-7562 Installation Manual

The following ancillary hardware to attach the extension arm to the mounting bracket is
included in the extension arm kit:
Description
1/2 inch hex head nut
1/2 inch x 3/4 inch hex head bolt

Pole Mounted Installations

The mounting hardware kit and extension arm can be used in various combinations to
properly install the AP-7562 on a pole. For poles up to 3 inches in diameter, attach the pole
mount bracket of the mounting hardware kit at the desired position on the pole using band
clamps up to 3/4 inch width, or a 1/2 inch x 4 inch wide U-bolt and nuts. For poles greater
than 3 inches in diameter, attach the pole mount bracket using band clamps.
CAUTION
Always mount the AP-7562 with the black gore vent facing down.
NOTE
The U-bolt and band clamps are not included in the mounting bracket kit.
AP-7562 Installation Guide
Hardware Mounting and Installation
Quantity
2
2
23