The Initial Setup Wizard - Extreme Networks Altitude 4760 Series Installation Manual

Table of Contents

The Initial Setup Wizard

Once the Access Point is installed and powered on, complete the following steps to get the

device up and running by using the Initial Setup Wizard:

1 Attach an Ethernet cable from the Access Point to a controller with an 802.3af compatible

power source or use the PWRS-14000-148R power supply to supply power to the

Altitude 4760 Series Access Point (once fully cabled).

If your host system is a DHCP server, an IP address is automatically assigned to the

Altitude 4760 Series Access Point and can be used for device connection. However, if a

DHCP server is not available, you will need to derive the IP address from the Altitude

4760 Series Access Point MAC address. Using this method, the last two bytes of the

Altitude 4760 Series Access Point MAC address become the last two octets of the IP

address.

For Example:

MAC address -

00:C0:23:00:F0:0A

IP address equivalent -

To derive the Altitude 4760 Series Access Point's IP address using its factory assigned

MAC address:

a Open the Windows calculator be selecting Start > All Programs > Accessories >

Calculator. This menu path may vary depending on your version of Windows.

b With the Calculator displayed, select View > Scientific. Select the Hex radio button.

c Enter a hex byte of the Altitude 4760 Series Access Point's MAC address. For

example, F0.

d Select the Dec radio button. The calculator converts F0 into 240. Repeat this process

for the last Altitude 4760 Series Access Point MAC address octet.

Altitude™ 4760 Series Access Point Installation Guide

169.254.240.10

Table of Contents