Extreme Networks Altitude 4760 Series Installation Manual page 35

Altitude 4760 Series Access Point Hardware Mounting and Installation
2 Using a torque wrench, or a ratchet and a 10mm socket, or an adjustable wrench, attach
(but do not tighten) the Access Point bracket section to the Altitude 4760 Series Access
Point with four M6 hex flange screws and insert two M6 hex flange screws into the
bottom holes on the sides of the Access Point bracket section.
3 With the Access Point positioned so that the gore vent is facing down, insert the two M6
hex flange screws in the bottom holes on the sides of the Access Point bracket section
into the open slot connections on the bottom of the angle adapter bracket section.
4 Rotate the Access Point bracket section upward and align the top holes on the sides with
the top holes on the angle adapter bracket section. Insert two M6 hex flange screws into
the top holes on the angle adapter bracket section.
5 Use a torque wrench, or a ratchet and a 10mm socket, or an adjustable wrench, to finish
attaching the angle adapter bracket section to the Access Point bracket section with the
four M6 hex flange screws in the open slot connections and the top holes on the angle
adapter bracket section. Do not tighten the screws until all rotation and tilt adjustments
are complete.
Altitude™ 4760 Series Access Point Installation Guide
35