Table of Contents
Advertisement
Altitude 4760 Series Access Point Power Options Using Power over Ethernet
NOTE
Product installation and mounting instructions are provided with the outdoor power injector.
Refer to the power injector installation guide.
If located within 100 meters of the controller and a PoE port is available, the Altitude 4760
Series Access Point can also be connected directly to one of the following Extreme Networks
controllers:
Summit WM3400
●
Summit WM3411
●
Summit WM3600
●
A standard CAT5E cable can be used to provide the connection to the Altitude 4760 Series
Access Point. The GE1/POE port on the Altitude 4760 Series Access Point is where the
standard CAT5E cable will connect to the Access Point and use of the weatherproof RJ45
plug kit that comes with the unit will maintain a weatherproof seal for outdoor installation
at the ethernet port.
If a CAT5E cable is used to connect the Altitude 4760 Series Access Point to a WM
Controller through a building egress, a suitable lightning protection system should be
considered. A professional installer should be consulted to identify an appropriate system.
CAUTION
When using controllers, the total power limits for the Altitude 4760 Series Access Point must
be considered. The two-radio configuration draws less power than a three-radio configuration. If
sufficient power is not available, the Altitude 4760 Series Access Point software will disable the third
radio and throttle back performance on all radio and Ethernet interfaces.
Altitude™ 4760 Series Access Point Installation Guide
38
Advertisement
Table of Contents
