Table of Contents
Advertisement
Altitude 4760 Series Access Point Hardware Mounting and Installation
6 Rotate the Access Point bracket section upward and align the top holes on the sides with
the top holes on the angle adapter bracket section. Insert two M6 hex flange screws into
the top holes on the angle adapter bracket section.
7 Use a torque wrench, or a ratchet and a 10mm socket, or an adjustable wrench, to finish
attaching the Access Point bracket section to the angle adapter bracket section with the
M6 hex flange screws in the open slot connections and the top holes on the angle
adapter bracket section. Do not tighten the screws until all rotation and tilt adjustments
are complete.
8 To adjust the position of the Access Point, rotate the Access Point bracket section (plus or
minus 15 degrees) and tilt the angle adapter bracket section (up to 45 degrees).
9 Tighten all hex flange screws to 60 inch pounds (lbf-in).
To Use the Extension Arm with The Mounting Hardware Kit:
1 Attach the pole mount section at the desired mounting location using a U-bolt or band
clamps.
2 Complete the steps for assembling and positioning the mounting bracket sections for
poles less than or greater than 3 inches outlined above.
3 Using a torque wrench, or a ratchet and a 10mm socket, or an adjustable wrench, attach
the extension arm to the Access Point bracket section with four M6 hex flange screws.
Tighten the hex flange screws to 60 inch pounds (lbf-in).
4 With the Access Point positioned so that the gore vent is facing down, attach the
extension arm to the Access Point with four M6 hex flange screws. Tighten the hex
flange screws to 60 inch pounds (lbf-in).
Altitude™ 4760 Series Access Point Installation Guide
33
Advertisement
Table of Contents
