Power Supply
Reduce RF Exposure - Use Properly
Only operate the device in accordance with the instructions supplied.
Remote and Standalone Antenna Configurations
To comply with FCC RF exposure requirements, antennas that are mounted externally at
remote locations or operating near users at stand-alone desktop of similar configurations
must operate with a minimum separation distance of 28 cm from all persons.
Power Supply
Use only a power-over Ethernet 802.3at compliant solution. The required power rating is
25.5 Watts.
Wireless Devices - Countries
Country Selection
Select only the country in which you are using the device. Any other selection will make the
operation of this device illegal.
Operation in the US
The available channels for 802.11 b/g operation in the US are Channels 1 to 11. The range of
channels is limited by firmware.
The FCC requires that the FCC ID label be placed on the outside of the device. If the device
is placed in a protective enclosure that requires tools to access, a permanent label with FCC
ID must be placed on the exterior of the protective enclosure
Altitude™ 4760 Series Access Point Installation Guide
74