Extreme Networks Altitude 4760 Series Installation Manual page 54

Chapter 3: Initial Access Point Configuration
16 Set the following DHCP and Static IP Address/Subnet information for the WAN
interface:
Use DHCP - Select the checkbox to enable an automatic network address
●
configuration.
Static IP Address/Subnet - Enter an IP Address/Subnet and gateway for the Access
●
Point's WAN interface. These are required fields
The port connected to the WAN - Select the port used as the physical Access Point
●
connection to the external network. The ports available differ depending on the
Access Point model deployed. Access Point models with a single port have this
option fixed.
Enable NAT on the WAN Interface - Select the checkbox to allow traffic to pass between
●
the Access Point's WAN and LAN interfaces.
17 Select Next. The Initial AP Setup Wizard displays the Radio Configuration screen to define
support for the 2.4GHz radio band, 5GHz radio band or to set the radio's functionality
as a dedicated sensor.
54
Altitude™ 4760 Series Access Point Installation Guide