Table of Contents
Advertisement
Altitude 4760 Series Access Point Hardware Mounting and Installation
For Mounting with Band Clamps:
1 Attach the pole mount bracket section at the desired mounting location using band
clamps.
2 With the angle adapter bracket section positioned so that the open connector slots are on
the bottom, attach the angle adapter bracket section to the pole mount bracket section
using two 1/2 inch bolts and nuts. Tighten the nuts to 30 inch pounds (lbf-in).
3 Position the Access Point bracket section so that the bottom of the section with the
straight (not bevel cut) sides is oriented toward the bottom side of the AP with the gore
vent. Using a torque wrench or a ratchet and a 10mm socket, or an adjustable wrench,
attach (but don't tighten) the Access Point bracket section to the Altitude 4760 Series
Access Point with the with four M6 hex flange screws.
4 Insert two M6 hex flange screws into the bottom holes on the sides of the Access Point
bracket section.
5 With the Access Point positioned so that the gore vent is facing down, insert the two M6
hex flange screws in the bottom holes on the sides of the Access Point bracket section
into the open slot connections on the bottom of the angle adapter bracket section.
Altitude™ 4760 Series Access Point Installation Guide
32
Advertisement
Table of Contents
