Port Forwarding Configuration Page - Hughes HX90 User Manual

Table 7: System Information page parameters – HX90 Info section
Parameter
Site ID
Serial number
Zipcode
Software Date
Software Release
LAN1 IP Address
LAN1 Subnet Mask
LAN1 MAC Address

Port Forwarding Configuration page

Identifies the site where the router is installed.
The router's serial number. The serial number may be required for
troubleshooting.
ZIP code of the router site.
Software build date.
Version of the router's software. This is typically the factory-installed
software version. However, if the NOC downloads a newer version of
Gateway software to the router, the newer version number is
displayed.
The satellite router address. The default router address is 192.168.0.1.
A different router address can be configured.
Range of addresses available to the satellite router.
MAC address for the satellite router.
Note: The Port Forwarding Configuration page and link are present on your HX90
only if they have been enabled by the NOC.
The Port Forwarding Configuration page and the link to it are present only if port
forwarding has been enabled and made visible on the router by the NOC.
On this page you can define rules for allowing TCP and UDP traffic on the Internet to
access servers on your network.
Figure 20: Port Forwarding Configuration page
Explanation
Chapter 2 • System Control Center
1039457-0001 Revision A
33