Lexmark MS312 User Manual page 91

Understanding the printer menus
MS315 and MS415 network/ports menus
Standard Network or Network [x] menus
Note: Only active ports appear in this menu.
Use
Energy Efficient Ethernet
Enable
Disable
PCL SmartSwitch
On
Off
PS SmartSwitch
On
Off
NPA Mode
Off
Auto
Network Buffer
Auto
3KB to [maximum size allowed]
To
Set the printer Ethernet connection to a energy‑saving mode.
Note: Enable is the factory default setting.
Set the printer to automatically switch to PCL emulation when a print job requires
it, regardless of the default printer language.
Notes:
•
On is the factory default setting.
• When Off is used, the printer does not examine incoming data. The printer
uses PostScript emulation if PS SmartSwitch is set to On. It uses the default
printer language specified in the Setup menu if PS SmartSwitch is set to Off.
Set the printer to automatically switch to PS emulation when a print job requires it,
regardless of the default printer language.
Notes:
•
On is the factory default setting.
•
When Off is used, the printer does not examine incoming data. The printer
uses PCL emulation if PCL SmartSwitch is set to On. It uses the default printer
language specified in the Setup menu if PCL SmartSwitch is set to Off.
Set the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol.
Notes:
• Auto is the factory default setting.
•
Changing this setting from the control panel, and then exiting the menus
causes the printer to restart. The menu selection is then updated.
Set the size of the network input buffer.
Notes:
•
Auto is the factory default setting.
•
The value can be changed in 1‑KB increments.
• The maximum size allowed depends on the amount of memory in the printer,
the size of the other link buffers, and whether Resource Save is set to On or
Off.
•
To increase the maximum size range for the Network Buffer, disable or
reduce the size of the parallel, serial, and USB buffers.
•
Changing this setting from the control panel and then exiting the menus
causes the printer to restart. The menu selection is then updated.
91