Lexmark MS312 User Manual page 166

Troubleshooting
Network [x] software error [54]
Try one or more of the following:
•
From the control panel, press
• Turn off the printer, wait for about 10 seconds, and then turn the printer back on.
•
Update the network firmware in the printer or print server. For more information, go to
http://support.lexmark.com.
Non‑Lexmark [supply type], see User's Guide [33.xy]
Note: The supply type can either be a toner cartridge or an imaging unit.
The printer has detected a non‑Lexmark supply or part installed in the printer.
Your Lexmark printer is designed to function best with genuine Lexmark supplies and parts. Use of third-party supplies
or parts may affect the performance, reliability, or life of the printer and its imaging components.
All life indicators are designed to function with Lexmark supplies and parts, and may deliver unpredictable results if
third-party supplies or parts are used. Imaging component usage beyond the intended life may damage your Lexmark
printer or its associated components.
Warning—Potential Damage: Use of third-party supplies or parts can affect warranty coverage. Damage caused by
the use of third-party supplies or parts are not covered by the warranty.
To accept any and all of these risks and to proceed with the use of non-genuine supplies or parts in your printer,
press and on the control panel simultaneously for 15 seconds to clear the message and continue printing.
If you do not wish to accept these risks, then remove the third‑party supply or part from your printer, and then install
a genuine Lexmark supply or part.
Note: For the list of supported supplies, see the "Ordering supplies" section of the User's Guide or go to
www.lexmark.com.
Not enough free space in flash memory for resources [52]
Try one or more of the following:
• From the printer control panel, press
• Delete fonts, macros, and other data stored in the flash memory.
From the printer control panel, navigate to:
> Settings >
Yes >
•
Use a larger‑capacity flash memory card.
Note: Downloaded fonts and macros that are not stored in the flash memory are deleted when the printer is turned
off or restarted.
Printer had to restart. Last job may be incomplete.
From the printer control panel, select Continue to clear the message and continue printing.
to continue printing.
to clear the message and continue printing.
> Settings > > Print Settings > > Utilities Menu >
166
> Format Flash > >