Lexmark MS312 User Manual page 103

Understanding the printer menus
Use
Paper Sizes
US
Metric
Timeouts
Sleep Mode
Disabled
1–120
Timeouts
Print with Display Off
Allow printing with display off
Display on when printing
Timeouts
Hibernate Timeout
Disabled
1–3 hours
6 hours
1–3 days
1–2 weeks
1 month
Timeouts
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Timeouts
Screen Timeout
15–300
To
Specify the unit of measurement for paper sizes.
Notes:
•
US is the factory default setting.
•
The initial setting is determined by your country or region
selection in the initial setup wizard.
Set the amount of time in minutes the printer waits after a job is
printed before it goes into a reduced power state.
Notes:
•
20 is the factory default setting.
•
Disabled appears only when Energy Conserve is set to Off.
•
The maximum amount of time is increased to 240 minutes
when Energy Conserve is set to Off.
•
Lower settings conserve more energy, but may require
longer warm‑up times.
•
Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm‑up time.
Print a job with the display turned off.
Note: Display on when printing is the factory default setting.
Set the amount of time the printer waits before it enters Hibernate
mode.
Note: 3 days is the factory default setting.
Set the printer to Hibernate mode even if there is an active Ethernet
connection.
Note: Do Not Hibernate is the factory default setting.
Set the amount of time in seconds before returning the control
panel to a Ready state.
Note: 30 is the factory default setting.
103