Supply Needed To Complete Job; Too Many Flash Options Installed [58]; Too Many Trays Attached [58]; Unformatted Flash Detected [53] - Lexmark MX310 Series Service Manual

Supply needed to complete job

Do either of the following:
•
Install the missing supply to complete the job.
•
Cancel the current job.

Too many flash options installed [58]

1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra flash memory.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.

Too many trays attached [58]

1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra trays.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.

Unformatted flash detected [53]

Try one or more of the following:
• From the printer control, select Continue to stop the defragmentation and continue printing. For non‑touch‑screen
printer models, press
•
Format the flash memory.
Note: If the error message remains, then the flash memory may be defective and need to be replaced.

Weblink server not set up. Contact system administrator.

Select Continue to clear the message. For non‑touch‑screen printer models, press
Note: If the message appears again, then contact your system support person.
to confirm.
Diagnostic information
90
7015
to confirm.