Device Location; A.5 Device Location - Image Access WideTek 36C Manual

A.5

Device Location

Please allow a minimum of 150 mm (6 inch) from any side walls and 300 mm (12 inch)
from a back wall. Leave one meter (3 feet) minimum distance from any door or entrance
way. Use illustration below as a guide.
Do not operate the scanner in an area that has poor air circulation, and/or that is non-
ventilated.
Place the WideTEK ®
must correspond to the device weight.
It is recommended to place the WideTEK
with the scanner. The floor stand gives the best ergonomic position when using the
scanner.
Choose a location that complies with the limits of temperature and humidity. Refer to the
technical specification.
Before using the WideTEK
Note:
one hour for temperature adaptation.
Temperature adaptation means:
A fast change from cold to warm environmental conditions can build up
condensation inside the housing. This will result in unfavorable scanned images
and could cause permanent damages to the unit.
Page 16
Picture 1: Minimum distances to the scanner
36C
on a flat and solid base. The load bearing capacity of the base
®
® 36C
36C
always on the floor stand which comes
scanner in the new environment allow at least
Manual