Front Panels And Drives; Front Bezel - Mitsubishi Electric APRICOT FT4200 Owner's Handbook Manual

5

FRONT PANELS AND DRIVES

Warning Warning
Read completely the instructions detailed in chapter 3 at the beginning of the
service section.

Front Bezel

Removing
1. Ensure that the removable media drive bay door is closed and locked.
2. On each side of the server, remove the protective metal plates which
cover the removable media drives and the electronics chamber.
3. Remove any hard disk drive module close to the front of the machine.
For detailed information see previous chapter.
4. Remove eight screws, four on each side of the machine, and slide the
bezel away from the chassis as shown in the following diagram:
Figure 5-1 Removing Front Bezel
1. Front Bezel
2. Front Panel System Controller
Connector
5. The front panel is attached to the bezel and comes away from the
chassis at the same time. Since there is a ribbon cable attached to the
front panel, remove the bezel with care.
6. Reach behind the bezel and disconnect the ribbon cable from the front
panel.
1
F r o n t p a n e l s a n d d r i v e s
2
COMPAC
T
Cass ette
Drive
Ope n/Cl
ose
S LO T-
4
DC
Write Prot
ect
Step
3. Securing Screws (x 8)
3
5/1