Front Panel - Mitsubishi Electric APRICOT FT4200 Owner's Handbook Manual

F r o n t p a n e l s a n d d r i v e s
Fitting
1. Ensure that any hard disk drive module close to the front of the
machine is removed.
2. Plug the ribbon cable into the connector on the front panel.
3. Fit the bezel onto the chassis and connect the eight screws, four on each
side of the server, as shown in the following diagram:
Figure 5-2 Refitting Front Bezel
1. Front Bezel
2. Front Panel System Controller
Connector

Front Panel

Removing
1. With the front bezel removed and the ribbon cable disconnected from
the front panel, remove the circlip from the top hinge of the removable
media drive bay door (which should be closed and locked).
5/2
1 2
COMPA CT
Cass ette
Driv e
Ope n/Cl
ose
S LO T
-4
DC
Writ e Prot
ect
Step
3. Securing Screws (x 8)
3