Table of Contents
Advertisement
U P S a n d b a t t e r y p a c k
7.
Loosen four floating fasteners, two on each side of the server, until they
are free of the power supply unit, as indicated in the following diagram:
Figure 10-4 Power Supply Floating Fasteners
1.
Floating Fasteners
8.
Now remove six screws on the back panel of the server, as shown:
Figure 10-5 Power Supply Securing Screws
9.
Using the handle on the battery pack, pull the unit carefully until it is a
little less than halfway out (about 30 cm), just before it begins to tip
towards you.
10/4
2
1
2.
Front Bezel
Advertisement
Table of Contents
