Table of Contents
Advertisement
H a r d d i s k d r i v e s a n d m o d u l e s
Removing a drive
1.
Turn the hard disk tray release handle anti-clockwise until it stops,
which is almost one complete turn. As you turn the handle, the tray
ejects slightly.
1
2
Figure 4-2 Release Handle Rotation
1.
Disk Drive Tray
2.
If you are removing the disk while the system is powered up, wait at
least 10 seconds to allow the disk to stop spinning and the heads to
park before continuing with this procedure.
Figure 4-3 Hard Disk Tray Removal
3.
Slide the tray out carefully until it is free of the chassis.
4.
Place the assembly into suitable packaging.
Note
Note
Since the hard disk drives for your Apricot are exclusively SCSI drives, it is
important to note that the SCSI connector on the backplane of the drive module
contains the device address. This means that, for a given connector, any disk
drive that is fitted to that connector will have the same SCSI address.
4/2
2.
Disk Tray Release Handle
Advertisement
Table of Contents
