Table of Contents
Advertisement
Fitting
1.
Attach the front panel to the supporting metalwork by means of the
eight screws as shown:
1
Figure 5-7 Front Panel Securing Screws
1.
Front Panel
2.
Securing Screws
Note
Note
Be sure to fit the two securing holes, marked '3', over the small metal protrusions
in the metalwork.
2.
Insert the front panel framework into the bezel as shown:
Figure 5-8 Fitting Front Panel Supporting Metalwork
1.
Front Panel Supporting Metalwork
3.
Fasten the framework onto the bezel using the two screws.
4.
Attach the top hinge of the removable media drive bay door to the front
panel supporting metal work you just fitted.
F r o n t p a n e l s a n d d r i v e s
2
3
2
3.
2
1
3
Metal Protrusion Holes
2.
Securing Screws
5/5
Advertisement
Table of Contents
