Table of Contents
Advertisement
F r o n t p a n e l s a n d d r i v e s
5.
Lift the tray away from the drive.
Fitting
Your server is equipped with a tray and a blanking plate for each empty drive
bay.
1.
Remove the blanking plate, if necessary, from the drive tray. The plate
is attached via two screws on the underside of the tray.
2.
Fasten the drive onto a drive tray using the four securing screws as
shown above. The tray allows for a small amount of adjustment. Align
carefully, if the drive is too far forward it may prevent the front panel
door from closing.
3.
Turn the drive upright, slide it into the drive cage and secure it to the
cage using the two screws.
4.
Connect the power cable to the back of the drive and the other end to
the socket on the centre spine.
5.
If you are fitting a SCSI drive, you will need to connect it to the bus
cable which is attached to any other SCSI removable media drives that
are present.
Note
Note
When fitting SCSI devices, the unit ID must be set so as not to conflict with any
other SCSI device already in the system. It is advisable to keep a secure written
record of all devices, IDs and their function/position.
5/8
Advertisement
Table of Contents
