Table of Contents
Advertisement
S M C a n d f a n
Fitting
1.
Fit the assembly so that the two metal tabs at the bottom are inserted
into corresponding slots. The assembly will then have a natural tilt
towards the interior of the server.
2.
On each side of the assembly there is also a smaller tab which fits into a
corresponding slot in the chassis. Squeeze the sides gently until the tabs
fit into the slots.
3.
While holding the assembly in place, fasten it with the two screws on
the back panel of the server.
4.
Connect the fan cable to the top connector on the controller board.
Against each fan connector on the board there is a graphic which indicates
which fan cable should be plugged in:
For further information about dismantling the fan sub-assembly, see the
following chapter, which provides detailed instruction on the rest of the
internal system fans.
6/4
Top
Middle
Bottom
Advertisement
Table of Contents
