Table of Contents
Advertisement
Removing
Each drive is attached to a drive tray, which is in turn secured to the drive
cage. To remove a tray from the cage:
1.
Unplug the data and power cables from the rear of the drive. Unplug
the other end of the power cable from its socket on the centre spine.
2.
Remove the two drive tray securing screws from the side of the cage.
The following diagram shows the screws for three of the drives:
1
Figure 5-11 Removable Media Drive Bay (Internal)
1.
Drive Tray Securing Screws
2.
Drive Power Cables
3.
Slide the tray carefully toward the rear of the cage until it is free from
the metalwork.
4.
Turn the tray over and remove four screws from the underside.
Figure 5-12 Drive Tray Removal
1.
Drive Tray
2.
Drive Assembly
F r o n t p a n e l s a n d d r i v e s
3
1
2
2
3
3.
Drive Data Cables
C O M P
A C T
3.
Securing Screws
5/7
Advertisement
Table of Contents
