Network Controls - SMART Board Board 800ix2 Configuration And User's Manual

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface

Network controls

These commands control the integration properties of the projector.
Usable command Property
by power state
Standby On
/ idle
set or get network
set or get set or get vgaoutnetenable
get get netstatus
set or get set or get dhcp
set or get set or get ipaddr
set or get set or get subnetmask
set or get set or get gateway
set or get set or get primarydns
get set or get macaddr
62 smarttech.com/kb/170453
Valid values
• on
• off (default)
• on
• off (default)
• connected
• disconnected
• disabled
• on
• off (default)
A valid IPv4 address in
values between 0.0.0.0
and 255.255.255.255
A valid IPv4 address in
values between 0.0.0.0
and 255.255.255.255
A valid IPv4 address in
values between 0.0.0.0
and 255.255.255.255
A valid IPv4 address in
values between 0.0.0.0
and 255.255.255.255
xx-xx-xx-xx-xx-xx]
Notes
Enables or disables the
network module.
Same function as the "network"
property.
Reports if the network port on
the projector is or isn't
connected to a network.
When off, the projector's
network IP address,
subnetmask, gateway and
primary DNS values must all be
set manually.
An IPv4 address.
An IPv4 address.
An IPv4 address.
An IPv4 address.
The media access control
(MAC) identifier of the
projector's network module.