Network Settings - SMART Board Board 800ix2 Configuration And User's Manual

A P P E N D I X A
Remotely managing your system through a network interface

Network settings

This menu allows you to use or not use Dynamic Host Control Protocol (DHCP) and to set the
network-related addresses and names when DHCP is not used.
Submenu setting
DHCP
IP Address
Subnet Mask
Gateway
DNS
Group Name
Projector Name
Location
Contact
SNMP Enable
Read-Only Community
Read/Write Community
47 smarttech.com/kb/170453
Description
Determines if the projector's IP address and other network settings
are dynamically assigned by a DHCP server or are manually set.
On allows the network's DHCP server to assign a dynamic IP
l
address to the projector.
Off allows you to manually set the projector's IP address and
l
other network settings.
Displays or allows you to set the projector's IP address in values
between 0.0.0.0 and 255.255.255.255.
Displays or allows you to set the projector's subnet mask number in
values between 0.0.0.0 and 255.255.255.255.
Displays or allows you to set the projector's default network gateway
in values between 0.0.0.0 and 255.255.255.255.
Displays or allows you to set the projector's IP address for your
network's primary domain name server in values between 0.0.0.0 and
255.255.255.255.
Displays or allows you to set the projector's workgroup name
(maximum 12 characters).
Displays or allows you to set the projector's name (maximum 12
characters).
Displays or allows you to set the projector's location (maximum 16
characters).
Displays or allows you to set the contact name or number for
projector support (maximum 16 characters).
Turns the Simple Network Management Protocol (SNMP) agent on or
off.
Sets a password that is required for each SNMP get request to
the device.
N O T E
The default for Read-Only Community is public.
Sets a password that is required for each SNMP set request to the
device.
N O T E
The default for Read/Write Community is private.