Network Controls - SMART Board Board 600i5 Configuration And User's Manual

A P P E N D I X A
Remotely managing your interactive whiteboard system
These commands inform you of the current audio output settings.
Command
get volume
get mute
get volumecontrol
get cc
These commands control your audio output settings. See Value-based command methods on page
65 for setting absolute and adjustment commands.
Command
set volume [value]
set mute [target]
set volumecontrol [target]
set cc [target]
N
N O T E
Typically, cc1 displays American English subtitles, while cc2 displays other regional languages,
such as French or Spanish, depending on television channel or media setup.

Network controls

These commands control your projector's network status and settings. These settings are available
even when the projector is in Standby mode. You must locally set the network and VGA out
commands to on, which is located in the OSD for the network abilities to work.
These commands inform you of the current network settings.
Command
get netstatus
get dhcp
get ipaddr
get subnetmask
get gateway
get primarydns
get macaddr
71
Response
volume=[current volume setting]
mute=[current mute setting]
volumecontrol=[current volume control setting]
cc=[current closed captioning language setting]
Command target range
=-20 to =20
=on
=off
=on
=off
=cc1
=cc2
=off
Response
netstatus=connected
netstatus=disconnected
netstatus=disabled
dhcp=[current DHCP status]
ipaddr=[current IP address]
subnetmask=[current subnet work mask number]
gateway=[current network gateway]
primarydns=[current primary domain name number]
macaddr=[current MAC address]
Response
volume=[value]
mute=[target]
volumecontrol=[target]
cc=[target]