Connecting Peripheral Sources And Outputs - SMART Board Board 800ix2 Configuration And User's Manual

A P P E N D I X D
Integrating other devices
Video system signal compatibility
The following tables list the projector's video system signal compatibility delivered over HDMI video
connectors, which you can adjust by using the aspect ratio commands described in Adjusting
projector settings.
Video mode
720p
720p
1080i
1080p
1080p
576i
480i

Connecting peripheral sources and outputs

Follow these instructions if you have a peripheral device to connect to your interactive whiteboard
system.
N O T E S
Measure the distance between the projector and the peripheral device you want to connect.
l
Make sure each cable has enough slack to be placed safely in your room without presenting a
trip hazard.
Do not disconnect cables from the ECP to connect peripheral devices because you could
l
disconnect controls for your interactive whiteboard.
To connect a laptop to a SMART Board 800ix2 interactive whiteboard system
1. Connect the VGA and USB cables from the notebook harness cable to the laptop.
2. Connect a VGA cable from the laptop computer to the projector.
OR
Connect an HDMI cable from the laptop computer to the projector.
T I P
Alternatively you can use a DVI-D-to-HDMI cable.
78 smarttech.com/kb/170453
Aspect ratio
16:9
16:9
16:9
16:9
16:9
5:4
4:3
Vertical frequency (Hz)
59.94
50
50
50.94
50
50
50.94