Projector Programming Commands; Projector Power State Controls - SMART Board Board 800ix2 Configuration And User's Manual

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
continue.
The room control feature of the projector is always on.
l
To configure your computer's serial interface
1. Turn on your computer, and then start your serial communications program or terminal emulation
program.
2. Connect your computer to the serial connection cable connected to the projector.
3. Configure your serial interface settings using the values in the previous table, and then press
ENTER.
The > character appears as a command prompt.
N O T E
If no message appears or an error message appears, your serial interface configuration isn't
correct. Repeat step 3.
4. Type commands to configure your settings.
N O T E S
To see a list of commands available in the current operating mode, type ? and then press
o
ENTER.
If you're using a terminal emulation program, turn on your program's local echo setting to
o
see characters as you type them.

Projector programming commands

This section documents the projector programming commands.

Projector power state controls

Your projector responds to commands only at certain power states and times.
There are six projector power states.
Command Control basics
? Commands the projector to output a list of commands that are available in the
projector's current operating mode. Note that some available commands might
not appear in the resulting list.
53 smarttech.com/kb/170453