Network Controls - SMART Board SB685ix2 Configuration And User's Manual

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface

Network controls

These commands control the integration properties of the projector.
Usable Command Property
by Power State
Standby On
/ Idle
set or get network
set or get set or get vgaoutnetenable
get get netstatus
set or get set or get dhcp
set or get set or get ipaddr
set or get set or get subnetmask
set or get set or get gateway
set or get set or get primarydns
get set or get macaddr
68 smarttech.com/kb/170510
Valid Values
• on
• off (default)
• on
• off (default)
• connected
• disconnected
• disabled
• on
• off (default)
[0~255].[0~255].[0~255].
[0~255] [a valid IPv4
address]
[0~255].[0~255].[0~255].
[0~255] [a valid IPv4
address]
[0~255].[0~255].[0~255].
[0~255] [a valid IPv4
address]
[0~255].[0~255].[0~255].
[0~255] [a valid IPv4
address]
[00~FF]-[00~FF]-[00~FF]-
[00~FF]-[00~FF]-[00~FF]
Notes
Enables or disables the
network module,
Same function as the 'network'
property.
Reports if the network port on
the projector is or is not
connected to a network.
When off, the projector's
network IP address,
subnetmask, gateway, and
primary dns values must all be
set manually.
An IPv4 address.
An IPv4 address..
An IPv4 address..
An IPv4 address.
The media access control
(MAC) identifier of the
projector's network module.