Chrysler Conquest 1988 Service Manual page 344

8-334
._I_
-. _-__.
ETACS - Checking Circuit
29.
Passing Relay Power-supply Circuit
To battery
Fuse
A-a
*i
(Front harness side)
(Front harness side)
16'13593 16'13593
NOTES NOTES
The check-table shown below is based upon the assumptiorxthat The check-table shown below is based upon the assumptiorxthat the passing relay drive circuit is normal.
the passing relay drive circuit is normal.
[Refer to check chart No. 28. In addition, the headlights (high beam) [Refer to check chart No. 28. In addition, the headlights (high beam) should go on when the passing~switch is
should go on when the passing~switch is
turned on -with ignition switch ACC or ON.] turned on -with ignition switch ACC or ON.]
Headlight
Passing
relay
1
Passing
control
relay
Disconnect
the ECU
harness
connector
and short
the terminal
@ (front
harness side,
BG line)
to drive.
the passing
relay.
B-a connec-
tor:
separation
CU: EIectronic~Control Unit
Harness dam- Repair the
harness.
age&or discon-
netted