Chrysler Conquest 1988 Service Manual page 309

ETACS
- Inspection Procedure by Input Check System
8-297
68Y534
FAST
68Y531
2. AlINT SWITCH -.
(1) Turn the ignition key to the LOCK position and open the
doors.
(2) Check to be sure that the indication of the voltmeter
connected to the diagnosis terminal moves by about 2V
or more when the wiper switch is set to the A/INT
position.
(3) If it does not, check as described in check chart No. 3
(Refer to P.8-303).
3. FAST/SLOW SWITCH
(1) Turn the ignition key to ON.
(2) Check to be sure that the buzzer sounds when the
FAST or SLOW switch is switched ON.
If the buzzer does not sound although the buzzer circuit
is normal, the problem is damaged or disconnected
wiring, or a short-circuit, of the FAST or SLOW switch
input circuit.
NOTE
(1) The buzzer circuit can be considered to be normal if
the buzzer sounds when another switch (CANCEL
or defogger) is used.
(2) If a malfunction is found as a result of the input
checking, check according to check chart No. 6
(Refer to P.8-306).
68Y53f
4. CANCEL SWITCH
(1) Turn the ignition key to ON.
(2) Check to be sure that the buzzer sounds when the
CANCEL switch is pushed.
(3) If there is a malfunction of the buzzer circuit, check to
be sure that the indication of the voltmeter connected
to the diagnosis terminal moves by about 2V or more by
pushing the CANCEL switch with the ignition key in
LOCK position and a door opened.
NOTE
If a malfunction is found as a result of the input
checking, check according to check chart No. 6 (Refer
to P.8-306).
5. DEFOGGER SWITCH
Check in the same way as CANCEL switch as shown
above.
NOTE
If a malfunction is found as a result of the input checking,
check according to check chart No. 19 (Refer to P.8-322).