Chrysler Conquest 1988 Service Manual page 298

8-286
OPERATION
ETACS
- Theft-alarm System
About 20 seconds after all doors are closed
and locked, the rear hatch is closed, and the
hood is closedy SYSTEM ARMED
Engine is disabled t9 start. .
1
\ ,
_ _
0 Driver opens door with the key.
' 8 \
SYSTEM DISARMED
16Y3575
1
-~
! ;.g
4. ARMING THE SYSTEM
After the following procedures: have been completed, the SECURIFT light illumrnates for about ,20 :
seconds, and when illumination stops, the system is armed.
(1) Pull out the ignition key from the key cylinder.
(2) Open a door. (The other door is closed.)
(3) Use the keyless-locking method to lock the door. .z
(The central door locking system will then function .to lock all doorsj
c_
NOTE
(1) The system IS not armed, and therefore does note function, if the key, is used- to lock the doors. =,
(2) Even after the system has been armed, If the key is used to open the rear hatch, the system tiill
not be actrvated; when the rear hatch is then closed, moreover, t~he system Will be armed. i
(3) in order to prevent the system's alarm from being accrdentally activated~by someone remaining in . _
the vehicle, the system is disarmed when, while-the SECURlt\/ light is illuminated,-? door is =
unlocked.
(4) If a door is locked by the keyless method but, in error, a door is not completely or securely closed,
the system will be disarmed. If this happens, the doors must be locked once again by the keyless
method.
(5) If the doors are locked while a door IS not closed completely, the SECURITY light will go-out after 1
20 seconds, but the system IS not armed. If this happens, the do5rs must be locked once again by :I
the keyless method.
(6) If a door is unlocked with the key while the SECURITY light is illuminated, the system will not be
armed.