Chrysler Conquest 1988 Service Manual page 273

ETACS - Outline
8-261
Power Operable
window Inoperable
Ignition
T---
ON -L__
switch
OFF
16R0083
16R0097
16R1311
SECU
RITY
1613574
7. POWER WINDOW TIMER
The power windows can be operated for about 30 seconds
after the ignition key is turned to OFF.
They stop, however, if a front door is opened.
NOTE
If the ignition key is turned to OFF while either (or both)
door is open, the power window delay timer will not
function, and the power windows cannot be operated.
input
output
Ignition switch (ON) Compulsory
Power window Power win-
actuation relay dow motor
input
(approx. 30- operation
second output) made possi-
Door
switch Timer stop ble
condition
8. THEFT-ALARM SYSTEM
This system is designed to protect the vehicle itself and its
contents against unauthorized forced entry after all doors,
the rear hatch and the hood have been closed and locked.
If an unauthorized forced entry occurs, the starter circuitry
will not function, and, moreover, visible and audible alarms
will result as the headlights illuminate and the horn sounds.
Confirmation of the system's setting is provided by
temporal illumination of the security light. (For additional
detailed information, refer to the section on P.8-285
concerning the theft-alarm system.)
NOTE
The interruption of the starter circuit will be maintained,
once the system has been activated, until it is deactivated.
If, however, the key is used, starting is possible even if the
alarm is not deactivated.
9. INPUT SIGNALS CHECK SYSTEM
The electronic control unit (ECU) of the ETACS provides the
input-check function for checking whether or not the
signals from the switches and sensors are correctly input to
the ECU.
The function checking signal is output as a certain fixed
pattern from the exclusive ETACS terminal of the self-
diagnosis harness connector located at the upper part of
the glove compartment. (For information concerning check-
ing procedures, refer to P.8-296.)