Chrysler Conquest 1988 Service Manual page 177

METERS AND GAUGES
- Service Adiustment Procedures
8-165
16Y356l
FUEL LEVEL SENSOR CHECK
1. Connect the gauge unit with a test light to- the battery, and
immerse it in the water.
2. The lamp should be off while thermistor of the gauge unit is
beneath the water, and should illuminate when the unit is
taken out of the water.
NOTE
If there is a malfunction, replace the fuel gauge as an
--
assembly.
Caution
After completing this test, wipe the unit dry and install
it in the fuel tank.
After the check, install the fuel gauge unit on the fuel tank and
apply sealant to the portion where the floor plug is to be
installed and then install the plug.
ENGINE COOLANT TEMPERATUkE GAUGE UNIT
INSPECTION
N08HIKB
To inspect the engine coolant temperature gauge unit, remove
the unit from the.,manifold.
ENGINE COOLANT TEMPERATURE GAUGE UNIT RESIST-
ANCE CHECK
Immerse the gauge unit in ho; water at 70°C (158°F) and
measure the resistance value with an ohmmeter.
Standard value: 90.5 - 117.5 R
--
After inspection, apply adhesive to the threaded portion of the
engine coolant temperature gauge unit and then install the unit
on the manifold.