Chrysler Conquest 1988 Service Manual page 28

L-- _____
_L:
SF=
INSPECTION OF HARNESS CONNECTOR -
-&
Inspection of Harness Connector
Ri?-*
ECI checker
16R1317
INSPECTION OF HARNESS :--
NOBCAAA
CONTINUITY AND VOLTAGE TEST FOR CONNEC-
TOR
Following procedures shall be jollowed for testing cortinuity
and voltage at connector in order to prevent improper contact
and deterioration of waterproof in connector.
CONVENTIONAL (NON-WATERPROOF) CONNECTOR
Check shall be
donciby
insertlng a probing needle from harness
side.
WATERPROOF CONNECTOR
Caution
Do not insert probing needle from harness side as it will
deteriorate waterproof and cause for rusting.
To inspect the energized circuit, use the ECI chec~ker.
CHECK FOR IMPROPER ENGAGEMENT OF TER-
MINAL
When terminal stopper of connector is out of order, .engage-
ment of male and. female terminals becomes improper even
when connector Aself is en-gaged perfectly and terminal
sometimes slips lout to rear side of connector. Ascertain,
therefore, that each terminal does not come off connector by
pulling each harness wire. :
ENGAGING AND DISENGAGING OF CONNECTOR "
1
TERMINAL
w=
Connector which gives loose engagement shall be rec$led $y
removing female terminal trom connector housing and raise
its' Lz~ ..
lance to establish securer engagemeyr. Removal of cqnnector MY
housing and raise rts lance to-establish securer .engaaement. : -x
--
Removal of connector terminal used for 'Xl .Zd ELC 4 A/T
control circuit shall be done rn the tollowing manner.
COMPUTER CONNECTOR
(I) Insert screwdriver [I .4 mm (.06 in.) width] as shown in the T
figure, disengage front holder and remove
it.