Chrysler Conquest 1988 Service Manual page 199

LIGHTING SYSTEM
- Troubleshooting
8-187
OPERATION
Turn Signal Lights
N08lHGC
When the turn signal light switch is at "L.H.",
with the ignition switch turned to "ON", current
flows through fuse No. 13, flasher unit, hazard
warning light switch, turn signal light switch,
turn signal lights (L.H.), and ground, causing the
flasher unit to alternately close and open its
contacts.
TROUBLESHOOTING HINTS
1. Turn signal liqhts do not work neither when turn
signal switchnor hazard warning light switch is
operated
As the contacts repeatedly open and close, the
turn signal lights (L.H.) flash.
The turn signal indicator light (L.H.) flashes at the
same time as do the turn signal lights.
When the turn signal light switch is at "R.H.",
the turn signal lights (R.H.) and turn signal
indicator light flash in the same way as when the
switch is at "L.H.".
Remarks
If one or more turn signal light bulbs are burnt out,
the flasher unit keeps the indicators illuminated, to
warn the driver that bulb replacement is required.
Hazard Warning Lights
Battery voltage is always applied to the hazard
warning light switch through fuse No. 3.
When the hazard warning light switch is turned
"ON", current flows through fuse No. 3, flasher
unit, hazard warning light switch, right and left
turn signal lights, and ground, causing the
flasher unit contacts to close and open repeated-
ly.
As the contacts repeatedly open and close, all of
the turn signal lights flash.
Both turn signal indicator lights flash at the same
time as do the turn signal lights.
l
Check hazard warning light switch.
2. Turn signal lights do not flash
1) Stop lights go on
l
Check the turn signal light switch.
2) Neither the turn signal lights nor the stop
lights operate
l
Check the hazard warning light switch