Chrysler Conquest 1988 Service Manual page 241

-
HORN
- Horn
8-229
16LO301
!-- 7
1 i3
by
4 :
2 : t
i-....-- 1
16LO312
16W908
(2) Check continuity between terminals when the battery
voltage is applied to the terminal 2 and the terminal 4 is
earthed.
HORN ADJUSTMENT
1. Secure the horn bracket in a vice, and then connect a 12V
battery.
2. Sound the horn, and adjust- it by turning the adjusting
screw.
(1) The sound volume is too low:
Turn the adjusting screw in the "UP" direction within a
range of about 180", and then lock it in position when a
satisfactory sound volume has been obtained.
(2) The sound volume is too loud:
Turn the adjusting screw 20" to 30" in the "DOWN"
direction, and then lock it in position when a satisfactory
sound volume has been obtained.
(3) Horn will not sound:
Turn the adjusting screw slightly in the "UP" direction
until the horn sounds, find a satisfactory sound volume
by continuing to turn the screw within a range of 180",
and then lock the screw in place.
If a satisfactory volume cannot be obtained, replace the
horn.
Caution
After the adjustment, apply lacquer to prevent the
adjusting screw from becoming loose.