Chrysler Conquest 1988 Service Manual page 260

--___---
8-248
AUDIO SYSTEM
- Power Antenna
I
l(iY1221
i
SERVICE POINTS OF REMOVAL
2. REMOVAL OF HIGH FLOOR SIDE PANEL
Make sure that-the antenna_ mast IS retracted before this
operatron. Disconnect the antenna relay before removing~
-~
the high floor srde panel. ~
-
8. REMOVAL OF SCUFF PLATE
Refer to GROUP 23 ~EXIDV - Trims. -- 4
INSPECTION
MOTOR ANTENNA
Following inspections shouldhe made with the harness -_
connector connected.
(1) With the (+) power connected to the terminal (1) and the (-)
'
power to the terminal (2),_check that the antenna mast 1
extends. With the connectjon reversed, check Jhat the .~
antenna mast retracts. 7
(2) Under the following anten? mast conditions, check con-
tinuity between terminals-
i
i._
NOTE
IIU? Indicates
that there IS contlnuty between the terminals.
MOTOR ANTENNA RELAY
With the harness connector connected and the antenna ma-st
extending/retracting, check the antenna relay voltage. ;:
:- _.
Antenna mast extending '- --
2
Terminal (1) . . . . . . .._ _._ ._...__ T . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1* -1 to -I- 1V
Terminal (4) .,....,.._ -___ _.._____...._.._._ __ _..__..,....___.__ _. 10 to 13V
Antenna mast retracting
Terminal (I) . . . . . . . . .._.._...... I........ ___ _-._. I ._...... _ . . . . _- IO Wl3V
Terminal (4) . . . . . . . . . . . . . . . . . . .._.......... __.__ ._._....... __ _...... ~-1 td-3 IV
.Z_~ -~