Chrysler Conquest 1988 Service Manual page 226

_I _~~_-- _-
8-214
WIPER AND WASHER SYSTEM
- Windshield Wipers
Mating marks
Battery
SERVICE POINT OF REMOVAL
5. CAUTION OF WIPER MOTOR
Caution
Because the installation angle of the crank arm and the
motor has been set, do not remove them unless it is
necessary to do so. If they must be removed, remove
them only after marking their mounting positions.
SERVICE POINTS OF INSTALLATION
6. INSTALLATION OF WIPER LINKAGE
When the passenger side~.pivot shaft is installed, use the r
access hole exposed by removal of cowl top outer cover
from the front deck.
. .
--~
-_
3. INSTALLATION OF WIPER ARM
Install the wiper arms on the pivot shafts so that the ;
stopping position of the wiper blades is in agreement with it
the standard value.
-
Standard value (distance between blade tip and front -
deck center garnish): 13 mm (.5 in.)
.-.
-as
INSPECTION
WIPER MOTOR
Disconnect the wiring connector from the wiper motor and I
connect battery to the wiper motor connector to check that~the ~;L
wiper motor runs.
-
. yes
LOW SPEED OPERATION CHECK
Connect battery (+) to terminal 4 and battery (-) to terminal 1 __
and check that the motor runs at !ow speed. _
: ~