Chrysler Conquest 1988 Service Manual page 159

IGNITION SYSTEM
- Service Adiustment Procedures
8-147
EL01 I
Then remove the distributor cap, turnttFEtor in then normal
direction (clockwise) by hand until it is blocked, and then return
it to its original position. Spark can be produced by moving the
projection of the signal rotor close to the stator in this manner.
Method 2
Remove the cap and rotor. Quickly move a screwdriver in and
out through the gap between the governor base and housing,
and spark can be produced as in Method 1.
Method 3
Remove the distributor from the engine (do not disconnect the
primary cable). While holding the distributor housing in contact
with the engine (to complete the ground circuit), turn the
distributor shaft, and spark can be produced as when the
engine is cranked.