Chrysler Conquest 1988 Service Manual page 10

a.2 5' ,. e;
,.
aY=Fa
s
INTRODUCTION -
Precautions before Service
PS '
PARTS
When replacrng parts, use MOPARgenurne parts.
m- -
nm (in.)
SOOO!
16C38(
/
-Cl6381
F16171
VEHICLE WASHING
If high-pressure car-washing equipment or steam car-washing
=
equipment is used to wash the vehicle, be sure to maintain the
spray nozzle at a distance of at feast 300 mm (12 in.) from any
plastic parts and all opening parts (doors, luggage compart- E
ment, sunroof, etc.).
"SERVICING ELECTRICAL SYSTEM
1. When servicing the electrical system, pay attention to the
following.
Never attempt to modify an electrical unit or td ~ohange
wirings, which may otherwise cause not only a* vehicle
failure but a vehicle fires-due to over-capacity load or -I
short-circuit.
_
2. Before servicing the electrical system, disconnect the -I
negative cable terminal from the battery.
Caution
Before connecting or disconnecting the negative cable,
be sure to turn off the ignition switch and the lighting
switch.
(If this is not done, there is the possibility of semicon-
ductor parts being damaged.)
WIRING HARNESSES
1. Secure the wiring harness- by using clamps: However, for
any harness which passes-to the engine orother vibrating i
parts of the vehicle, allow some slack within a range that ,-t
does not allow the engine-vibrations to cause the harness
to come into ~contact with any of the surrounding parts. HO-
Then secure the harness-by using a clamp.
In addition, If a mountrng rndicatron mark (yellow tape) is on .I
a harness, secure the indication mark in the specifjed
location.
2. If any sectionof a wiring harness contacts the edge of a :.I;
part, or a comer, wrap the section of the harness with tape
or something similar in order to protect it from damage.
=z