Chrysler Conquest 1988 Service Manual page 148

g__
STARTING SYSTEM
- Starter Motor
c
E l&l
+ Wear limit line
IELOll
New brush
Soldered
(Make sure that
there is no exces:
solder on brush
surface)
1 EL04'
Growler
BRUSH HOLDER
Check the continuity betweenbrush holder plate and brush
_
holder.
-
If there is no continuity, the brush holder is in order-. ~~ ._I:
OVERRUNNING CLUTCH
(1) While holding clutch housing, rotate the pinion.-
.L
Drive pinion should rotatesmoothly in one direction, but '~
should not rotate in opposite direction,
(2) Check the pinion for wear. and damage.
BRUSHES AND SPRINGS - REPLACEMENT .-
1. Brushes that are worn beyond wear limit line, or are ._
oil-soaked, should be replaced.
2. When replacing field coil brushes, crush worn brush with 1
pliers, taking care not to damage pigtail.
3. Sand pigtail end with sandpaper to ensure good soldering.
4. Insert pigtail into hole provided in new
brush
and solder jt. =
Make sure that pigtail and excess solder do not come out .I
onto brush surface.
5. When replacing ground brush, slide the brush from brush _:l
holder by prying retaining spring back.
~_
.-
TESTING ARMATURE
TESTING ARMATURE FOR SHORT-CIRCUIT
1. Place armature
i-n
a growler.
2. Hold a thin steel blade parallel and just
above
while rotating
armature slowly in growlerr A shorted armature will cause ~m5
blade to vibrate and be attracted to the core,_peplace --
shorted armature.
I CL-r