Chrysler Conquest 1988 Service Manual page 167

IGNITION SYSTEM
- Distributor
8-155
Coil resistance
measuring terminals
6EL02
6EL03E
6EL03E
6EL040
INSPECTION
PICK-UP COIL
(1) Using an ohmmeter, measure resistance of pickup coil.
Resistance value: 920 - 1,120 fZ
Caution
Do not insert tester probe into igniter connecting
terminals,
as damage
to terminals could result.
(2) When coil resistance is to be measured without disassemb-
ling distributor assembly, insert tester probes through
portions shown in illustration.
SERVICE POINTS OF REASSEMBLY
23. INSTALLATION OF DRIVEN GEAR / 22. SPRING PIN
(1) Install driven gear into distributor shaft at previously
marked location. Then install new roll pin.
(2) Align punch mark on gear with mating mark on housing,
check to ensure that notched portion of shaft end is
positioned as shown, and then install a pin to secure the
gear to the shaft.
19. INSTALLATION OF STATOR
Before the stator is installed, check to ensure that there are
no iron filings or iron pieces on the stator.
12. INSTALLATION OF GOVERNOR BASE AND SIGNAL
ROTOR ASSEMBLY
After the governor assembly has been installed, turn the
shaft to confirm that the projection of the signal rotor does
not touch the stator.