8.3
Converting a PINpad from PC-EFTPOS Mode to Standalone Mode (i5100 only)
Standalone Mode (not applicable to i3070)
The i5100 supports a simple standalone mode.
The menu system represents the user interface for the terminal. The menu allows the operator to access all of
the terminal functionality without the need for a POS system.
Configure Standalone Mode
Call the CBA Help Desk on 1800 022 966 and ask them to edit the TMS (Refer section 6 for
further information) and disable PC-EFTPOS.
Plug the phone line into i5100 terminal.
Open the EFT Client
Change "Host Interface Address" to NPT and then click on Apply
On the i5100 terminal press [Func] and then [9]
Type in your hidden password*
Press [1] Terminal Config
Press [3] PC-EFTPOS Setup
Press [1] Internal Modem
Press [CHQ] for On (For some terminals the [CHQ] button will be the Top Left Yellow button).)
Perform a
TMS logon
*To obtain your hidden password, please call either CBA or PC-EFTPOS and have the last 6 digits
of the terminals serial number with you.
8.4
Converting an Existing PINpad from Standalone Mode to PC-EFTPOS Mode
PC-EFTPOS Mode
All the EFTPOS functionality is initiated through the POS, when in PC-EFTPOS mode.
Change terminal into
Call the CBA Help Desk on 1800 022 966 and ask them to edit the TMS (Refer section 6 for
further information) and enable PC-EFTPOS.
Check that the parameters that are setup on TMS are as per customers‟ needs.
Perform a
TMS logon
PC-EFTPOS-CBA i5100 / i3070 Guide
(as per above).
"PC-EFTPOS Mode"
(refer to section 5.0).
(see above)
Page 22
15/12/2008