Pc-Eftpos Hardware Installation - PC-EFTPOS i5100 Manual

PC-EFTPOS Hardware Installation

3.
3.1
i5100 EFTPOS Terminal
Installation Steps -
1. Power the terminal. Connect the supplied power pack to the wall socket.
2. Connect the power adaptor to the round DC power socket on the back of the terminal (connection A).
3. Connect the supplied POS connector cable (RS232 data cable) to the COM port on the PC (normally COM 1).
4. Connect the other end of the RS232 data cable to the RS232-1 connector on the back of the terminal
(connection C).
Note, that if you are using the Saturn contactless reader, the RS2323 data cable plugs in to RS232-2
5. If the terminal is using the terminal‟s internal modem, (i.e. single terminal application) plug the phone cable in
to the phone connector on the back of the terminal (connection B) and to your phone line socket on the wall.
PC-EFTPOS-CBA i5100 / i3070 Guide
Supplied Equipment with terminal:

i5100 EFTPOS Pinpad terminal

Power pack and power cable

Y Powered Curly Cable (contains the power cable and dial-up phone
cable connections)

POS connector cable (RS232 data cable)
(Identified by label "Ingenico CAB-0117-01")
Note: Merchants who want to accept MasterCard PayPass contactless cards
will also receive an OTI - Saturn 6000 contactless reader with cable.
Page 7 15/12/2008