PC-EFTPOS i5100 Manual page 10

Installation Steps (USB) (Not currently available at December 2008)
1. Plug the RJ connector of the USB data cable in to the back of the pinpad
2. Do not connect the PINpad to your PC until instructed to by the PC-EFTPOS installer.
This will be on the "Introduction" page of the Configuration Wizard
3. When instructed, connect the USB cable to the PC. This will bring up a "Found New Hardware Wizard"
(To view a guide on installing the USB driver, click on the appropriate link in the "Introduction" page of
the Configuration Wizard)
4. After installing the drivers, the PINpad should boot up. The PINpad is powered via USB.
5. Switch the PINpad to USB mode (refer to
6. Continue on and complete the rest of the Configuration Wizard
3.3
Dial-Up Modem
Equipment supplied with P66 Modem
 P66 modem
 Power supply and power cord
 PC connector cable (DB9 to RJ45)

(Identified by label "CAB0118")
 Dial-up phone cable and connector
Installation Steps:
1. Plug the power supply into a power point and the P66 Modem DIN connector,
2. Connect the phone cable to the "Line" connector on the P66 and to the phone line wall socket,
3. Connect the POS cable to the PC COM port and to the "Pinpad" connector on the P66 modem.
PC-EFTPOS-CBA i5100 / i3070 Guide
section 8.1).
 One P66 Modem is required for any store that requires dial-up
connectivity to the bank. The P66 modem utilizes a purpose built
EFTPOS modem to connect with the banking network.
 The modem can be shared between any number of EFTPOS
terminals within a network.
 There should only be one P66 modem within any single store.

Note: The internal modem of the 5110 pinpad can be used for sites with a
single 5110 pinpad and dial up line. This is a TMS setting that needs to be
changed by the CBA Helpdesk.
Page 10 15/12/2008